Table of Contents
Advertisement
1.
2.
TOOLS NEEDED FOR ASSEMBLY
#1 and
#2 Philips Screwdriver
Adjustable Wrench
Hammer or
rubber mallet
Place
the base on a flat
surface
and assemble the
column
to
the base using
the
four
M8
hex bolts.
-it
t
Locate the
worm gear and feed the Dishaft through
the
hole in the the table assembly as shown
in
Figure
4.
lnsert the D-shaft through the hole
in
the
table crank.
Align flat side
of
shaft with the set screw
on the
table
crank handle. Tighten set screw using
the
4 mm hex
wrench.
Feed the gear rack through the slot in the table
assembly
so that the teeth are facing out and the
longer smooth end faces
up.
The worm gear should
engage the gear rack.
Using
both hands, slide the entire assembly
onto
the
column until
the
bottom
of the gear rack
is
positioned against the base collar. See Figure
5.
4.
Slide
the column collar, bevel side down, over the
column until the beveled side engages the beveled
end
of the gear rack. Tighten the set screw in the
collar using
the4
mm
hex
wrench.
See
Figure
6.
Do
not overtighten
NOTE: Table should be able
to move side to
side.
Do
not overtighten
set screw.
Fig.6
Locate
the support lock handle. lnsert
it
into the
threaded hole at the rear
of
the
table assembly and
tighten by hand.
(*
6il'
''17);
Position head assemblyrupside down
on a
level,
flat
surface. Position chuck
on spindle. Chuck
should
be
fully opened to avoid damaging jaws. Using
a
scrap
block
to protect
the
chuck, firmly
tap
the
chuck
into
place using a hammer.
Lift head assembly on column with the spindle
positioned
over the
table.
Slide head
assembly down
as
far as
it
will go. Tighten the two head set screws
with the
4 mm hex wrench.
See
Figure
B.
5.
6.
3.
7.
set screw
worm gear
\
i9m=
,/-
crank
handle
Fig.4
1..=
')
-
base
cottar
10
Advertisement
Table of Contents
