Table of Contents
Advertisement
BevelAdjustment
Your
drill press
is
equipped with
a
tilting table that allows
you
to drill angled holes. The table can be tilted
left
or
right,
from 0-45 degrees.
To
tilt
the table, first loosen the table lock handle. Then
loosen
the large hex bolt located underneath the table.
See
Figure
71.
Use
the bevel scale to tilt table to
the
desired angle, then tighten hex bolt. Retighten the table
lock handle.
Table Rotation
When drilling large objects
it
may be necessary to swing
the table out
of
the way.
Simply
loosen the
table
lock lever,
rotate table, and retighten table lock
lever.
Note: When using the base as a work surface,
the
workpiece must
be
clamped securely
to
the
base.
DEPTH
STOP ADJUSTMENT
Where a number of holes are to be drilled to exactly the
same depth, the depth stops used are as follows:
Loosen scale
set
handle located on the feed shaft
assembly, rotate spindle depth
as
desired and tighten
scale
,t
/
Tohold a stationary depth, loosen scale set handle and
/
turn feed shaft to lowest point,
then rotate spindle depth
/
to
desired
depth and retighten scale set handle.
This
I
will
hold the spindle assembly stationary
at
desired
\
oeptr.
CHANGING SPEEDS
The spindle speed is determined by the location of the
belt on
the pulleys
in
the pulley housing. The reference
chart located inside the pulley housing shows
the
recommended speed and pulley conflguration for each
drilling operation. To change
the pulley
configuration,
refer
to Figure 14
and proceed as follows:
Loosen the
two
belt
tension knobs located on either side
of
the
head
assembly.
See
Figure
2.
Push the motor assembly toward the front of
the
head
assembly
to loosen the drive
belt.
Open
the pulley housing cover and reposition the
belt
according to the speed chart. Close the housing cover.
Push motor
firmly back to position assuring drive belt
is
tight. While holding tension on motor, retighten the two
belt
tension knobs securely.
See
Figure
2.
speed chart
-.
---.-
_
4<-
-)^)
scale
set
handle
,\-->
-\
^(
bevel scale
Fig.12
\
set
handle.
See
Figure
13.
t2
Advertisement
Table of Contents
