Single Housing End Attached To The Full Body Harness - Malta Dynamics C7002-G2 Instruction Manual

Single Housing End Attached to the FBH
The SRD housing end is installed to the dorsal D-ring of an FBH and the leg end
attached to a suitable anchorage.
To attach SRD on the Harness, Follow these steps:
30
O
1. Don the harness in accordance with the harness manufacturer's
instructions.
2. Insert the nose end of an ANSI compatible double-locking carabiner
through the SRD housing swivel eye.
3. Attach the carabiner to the dorsal D-ring of the FBH. Ensure the carabiner
gate is fully closed and locked.
4. Connect the leg end connector to an approved, suitable anchor that
meets work zone requirements.
MaltaDynamics.com | 800-494-1840
Figure 3A: Pygmy Hog SRD Orientation
and Acceptable Anchorage Range
6' & 10'
27
Manual Revision Code:
MD-20230508