Advertisement
ETC Installation Guide
Dual Tech Wall-mount Occupancy Sensor
4. Install the wall plate to the
mounting plate.
a. Align the top of the wall
plate to the mounting plate,
angling the bottom slightly.
b. Hook the top of the wall
plate to the tabs located on
the mounting plate.
c. Swing the wall plate down,
ensuring the neck of the
sensor extension and wires
feed through the opening,
until the magnets engage.
d. If the wall plate does not
fully attach, wiggle the
bottom of the plate until all of the magnets are seated properly.
5. Attach the sensor
head.
a. Slide the
removable cover
off the sensor
head.
b. Route the
three-position
connector with
wiring pigtail
through the
sensor head.
c. Loosen the set
screw on the
sensor retaining
ring.
d. Slide the sensor
onto the ball socket, and then tighten the set screw until secure.
6. Connect the three-position connector to the receptacle on the
sensor electronics.
Dual Tech Wall-mount Occupancy Sensor
c
b
a
Page 5 of 12
d
ETC
Advertisement
