Faults - UNITED OFFICE UAV 190 C2 Operating Instructions Manual

Faults

If the paper jams:
This means that you have attempted to feed too much paper into the appliance
(max. 6 sheets 80 g /m
♦ Move the switch
The appliance now goes into reverse and the material that is being shredded
is ejected.
♦ Pull the paper out of the appliance and then set the switch
♦ The appliance is now ready for use.
If the appliance suddenly stops working:
This means that the appliance is overheated and the automatic safety cut-out has
activated itself. The overheat LED
WARNING!
► Remove the power plug from the wall socket to avoid unintended restarting
of the appliance.
♦ Place the switch
♦ Empty the container.
♦ Allow the appliance to cool until it has cooled to room temperature.
♦ Put the mains plug back into the socket.
♦ Switch the appliance on by moving the switch
If the appliance cannot be switched on:
♦ Check that the plug is correctly connected to a wall socket.
♦ Try a different wall socket.
♦ The appliance is possibly defective. Have the appliance checked by qualified
specialists.
♦ Check whether the overheat LED
overheating protection has been triggered. Proceed as described in the sec-
tion Note regarding overheating of the appliance.
UAV 190 C2
2 paper).
1
into the REV position if the paper causes a blockage.
4
lights up red.
1
in the OFF position.
4
has come on. If it has come on, the
1
to AUTO.
1
into the AUTO position.
GB │ IE
│
9 ■