Samson 42-36 Mounting And Operating Instructions page 84

Certificates
Declaration of Incorporation of Partly Completed Machinery
in accordance
Supply of Machinery (Safety) Regulations 2008
For the following product:
Type 2423 Valve
We certify that the Type 2423 Valve is partly completed machinery as defined in the in Directive 2008 No. 1597 Supply of
Machinery (Safety) Regulations 2008 and that the safety requirements stipulated in Annex I, 1.1.2, 1.1.3, 1.1.5, 1.3.2, 1.3.4
and 1.3.7 are observed. The relevant technical documentation described in Annex VII, (Part 7 of Schedule 2) part B has
been compiled.
Products we supply must not be put into service until the final machinery into which it is to be incorporated has been declared
in conformity with the provisions of the Directive 2008 No. 1597 Supply of Machinery (Safety) Regulations 2008.
Operators are obliged to install the products observing the accepted industry codes and practices (good engineering practice)
as well as the mounting and operating instructions. Operators must take appropriate precautions to prevent hazards that
could be caused by the process medium and operating pressure in the valve as well as by the signal pressure and moving
parts.
The permissible limits of application and mounting instructions for the products are specified in the associated mounting and
operating instructions; the documents are available in electronic form on the Internet at www.samsongroup.com.
For product descriptions refer to:
- Type 42-34 and Type 42-38 Differential Pressure Regulators with Flow Limitation:
Mounting and Operating Instructions EB 3013
- Type 42-36 Flow Regulator: Mounting and Operating Instructions EB 3015
- Type 42-36 E Pressure-independent Control Valve (PICV):
Mounting and Operating Instructions EB 3018
- Type 42-37 Flow and Differential Pressure Regulator as well as Type 42-39 Flow and Differential Pressure or Pres-
sure Regulator: Mounting and Operating Instructions EB 3017
Referenced technical standards and/or specifications:
- VCI, VDMA, VGB: "Leitfaden Maschinenrichtlinie (2006/42/EG) – Bedeutung für Armaturen, Mai 2018" [German
only]
- VCI, VDMA, VGB: "Zusatzdokument zum Leitfaden Maschinenrichtlinie (2006/42/EG) – Bedeutung für Armaturen
vom Mai 2018" [German only], based on DIN EN ISO 12100:2011-03
Comments:
- See mounting and operating instructions for residual hazards.
- Also observe the referenced documents listed in the mounting and operating instructions.
Persons authorized to compile the technical file:
SAMSON AG, Weismüllerstraße 3, 60314 Frankfurt am Main, Germany
Frankfurt am Main, 27 April 2022
Stephan Giesen
Director
Product Management
Classification: Public · SAMSON AKTIENGESELLSCHAFT · Weismuellerstrasse 3 · 60314 Frankfurt am Main, Germany
14-12
with Schedule 2 Part 2 Annex II, section 1.B. of
Peter Scheermesser
Director
Product Maintenance & Engineered Products
the Directive 2008 No. 1597
Revision 00
Page 1 of 1
6
EB 3015 EN