ASAHI PENTAX Z-70 Operating Manual page 62

змоцунз4о азомулау | |
3. Select the desired shutter speed and the aperture
with the select dial.
* When you change the shutter speed, depress the
Tv." Av button to display [^] above the TV on the
LCD panel (The bar appears underneath the shutter
speed in the viewfinder). Then turn the select dial to
change the shutter speed.
When you change the aperture setting, depress the
the Tv." Av button until [^] appears above the Ау оп
the LCD panel (The bar appears underneath the aper-
ture value in the viewfinder.). Then turn the select dial
to change the aperture setting.
68
* When the dots are displayed to the [ & | side on the
bar graph, it indicates overexposure and when dis-
played to the [ © ] side, it indicates underexposure.
Moving one dot on the bar graph indicates 0.5 step
(0.5EV). However, when under or over exposure is
set beyond + З ог — З steps (SE), [8 ] or [@ ]
indicator will blink.
* When the hyper button (В 1 is depressed, (9 | is dis-
played on the LCD panel, the shutter speed remains
unchanged while the aperture is adjusted for a correct
exposure: when Г Др | is displayed on ће LCD panel,
the aperture remains unchanged while the shutter
speed is adjusted for a correct exposure (HYPER
MANUAL)
* When the hyper button [ @ ] is depressed, the dots in
the viewfinder and on the LCD panel move into the
center of the bar graph to indicate that a correct expo-
sure is obtained.
* In the manual exposure mode, when the shutter re-
lease button is depressed while depressing the Hyper
button [ & 1, the shutter speed and aperture setting
Will be changed to obtain a correct exposure even if
the brightness of the subject is changed. The expo-
sure is adjusted in a similar manner to as when the
Programmed AE mode is set.
* If the subject is too bright or dark, and both shutter
speed and aperture blink in the viewfinder and on the
LCD panel, it means that the exposure is out of meter-
ing range, unable to obtain a correct exposure. Use an
ND (neutral density) filter if the subject is too bright
or a flash if it is too dark.