Boot
In certain scenarios, you may require access to the boot mode for tasks such as firmware updates or
performing a factory reset in case of unstable firmware. To access the boot, follow these steps:
1. Wire both data output ports together.
2. Connect the DIN PIXIE to a computer via USB
cable and the LED will flash in red indicating it
is in boot.
3. Launch the EMU Software on your computer and
select
4. The EMU Software will prompt you to access the
boot page for firmware updates or other
maintenance tasks.
11
|
from the DIN PIXIE.
ID: 5935565
Visit the ENTTEC website for the latest version.
Document Updated: Nov 2023
DIN PIXIE (73539)
EMU Software
USER MANUAL
..
Need help?
Do you have a question about the DIN PIXIE and is the answer not in the manual?