Compressor Assembly; Storage And Transport; Setting Up - Danfoss BOCK F Operating Manual

4| Compressor assembly

INFO!

4.1 Storage and transport

?
Fig. 6
Fig. 7
Transport and suspension unit on the eyebolt (Fig. 9, F14 to F16) or direct on the discharge
line valve (Fig. 8, F2 to F5).
Fig. 8

4.2 Setting up

ATTENTION! Attachments (e.g. pipe holders, additional units, fastening parts,
3 2
Fig. 10
Fig. 11
Fig. 12
© Danfoss | Climate Solutions | 2023.07
New compressors are factory-filled with inert gas. Leave this
service charge in the compressor for as long as possible
and prevent the ingress of air. Check the compressor for transport
damage before starting any work.
Storage at (-30°C) - (+70°C), maximum permissible relative humidity
10% - 95%, no condensation
Do not store in a corrosive, dusty, vaporous atmosphere or in a com-
bustible environment.
Use transport eyelet.
Do not lift manually!
Use lifting gear!
etc.) directly to the compressor are not permissible!
1
Provide adequate clearance for maintenance work.
Provide adequate ventilation for the drive motor.
Do not use in a dusty, damp atmosphere or a combustible
environment.
Setup on an even surface or frame with sufficient load-bearing
capacity. Use all 4 fastening points.
Compressors and drive motors are basically rigid and should be
mounted together on a base frame.
Correct setup of the compressor and mounting of the belt drive are
decisive for running comfort, operating safety and the service life of
the compressor.
Fig. 9
F
E
D
AQ449946687878en-000201| 11
D
GB
F
Ru