Keysight M8100 Series Getting Started Manual page 39

M8199A
M8008A
M8100 Series Arbitrary Waveform Generators Getting Started Guide
Following are the possible ways to connect a M8008A clock source to the
M8199A AWG module(s):
Case 1 Connecting M8008A clock module to M8199A AWG module
In this case, make the connections as described below:
1 Connect the 1.85 mm, 45 cm M8199A-810 replacement channel clock
cable (M8199-61624) from Sample Clk Out of M8008A to Clk In of
M8199A.
2 Connect the 3.5 mm, 50 cm M8199A-811 sync cable (M8199-61620)
from Sync Out of M8008A to Sync In of M8199A.
Figure 13 shows how to connect the M8008A clock generator module to
the M8199A AWG module:
Figure 13 Connecting M8008A clock generator to M8199A AWG module
Basic Setup for M8100A 2
39