•
Push two flange bearings into each of the drive disk
assemblies. See figure 11.
DRIVE DISK
ASSEMBLY
FLANGED
BEARING
FIGURE 11
•
Push a flange bearing into each of the seven drive
disks, from the side shown in figure 12.
SPIKE DISK
FIGURE 12
•
Press flanged bearings into both of the end plates.
See figure 13.
•
Place the 1/4" thick spacer onto the spike disk
shaft and then insert the shaft through the flanged
bearing in the left hand end plate. See figure 13.
FLANGED
BEARING
FIGURE 13
FLANGED
BEARING
FLANGED
BEARING
FLANGED
BEARING
1/4" THICK SPACER
SPIKE DISK SHAFT
•
Place a short spacer tube, a drive disk, a 5/8" flat
washer, another drive disk and a second 5/8" flat
washer onto the shaft. Fit the short spacer tube onto
the flanged bearing in the end plate. See figure 14.
DRIVE DISKS
FIGURE 14
IMPORTANT: When assembling the spike disks, be sure
they face in the direction shown in the instructions.
•
Place two spike disks, separated by a long spacer
tube, onto the shaft. Fit the long spacer tube onto the
ends of the flanged bearings in the disks. See figure
15.
LONG SPACER TUBE
FIGURE 15
9
SHORT SPACER
TUBE
5/8" FLAT WASHER
SPIKE DISK