Craftsman SPIKER 486.24331 Owner's Manual page 10

• Place a 5/8" flat washer, the compression spring and
another 5/8" flat washer onto the shaft. See figure 16.
5/8" FLAT
WASHER
FIGURE 16
• Place two spike disks, separated by a long spacer
tube, onto the shaft. Fit the long spacer tube onto the
ends of the flanged bearings in the disks. See figure
17.
LONG SPACER TUBE
FIGURE 17
COMPRESSION
SPRING
SPIKE DISK
• Place two 5/8" flat washers separated by a long
spacer tube onto the shaft. See figure 18.
LONG SPACER TUBE
FIGURE 18
• Place two spike disks, separated by a long spacer
tube, onto the shaft. Fit the long spacer tube onto the
ends of the flanged bearings in the disks. See figure
19.
LONG SPACER TUBE
FIGURE 19
10
5/8" FLAT WASHER
SPIKE DISK