Real Time Clock - Toshiba Qosmio G30-150 User Manual

Problem
Battery doesn't power
the computer as long
as expected

Real Time Clock

Problem
The following
message is Displayed
on the LCD screen:
RTC battery is
low or CMOS
checksum is
inconsistent.
Press [F1] key to
set Date/Time.
Password
Problem
Cannot enter
password
User's Manual
Procedure
If you frequently recharge a partially charged
battery, the battery might not charge to its full
potential - in these instances you should fully
discharge the battery and then attempt to charge
it again.
Check the power consumption settings within the
TOSHIBA Power Saver and consider using a
power saving mode.
Procedure
The charge in the Real Time Clock (RTC) battery
has run out - you will need to set the date and
time in the BIOS setup application by using the
following steps:
1. Press the F1 key - the BIOS setup application
will load.
2. Set the date in the System Date field.
3. Set the time in the System Time field.
4. Press the End key - a confirmation message
will be displayed.
5. Press the Y key - the BIOS setup application
will end and the computer will restart.
Procedure
Please refer to the
section in Chapter 6,
information.
Troubleshooting
TOSHIBA Password Utility
Power for further
10-7