Table of Contents
Advertisement
Optional Devices
Use a #0 point Phillips screwdriver to remove and fasten the screws - the
use of an incorrect screwdriver can damage the screw heads.
Installing a memory module
The computer contains slots for two memory modules, one positioned
immediately over the other - the procedures are the same for installing
either module.
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the
Chapter 3,
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack
4. Loosen the screw securing the memory module cover in place - please
note that this screw is attached to the cover in order to prevent it from
being lost.
5. Slide your fingernail or a thin object under the cover and lift it off.
6. Align the notch of the memory module with that of the memory slot and
gently insert the module into the slot at about a 45 degree angle before
pressing it down until the latches on either side snap into place.
9-14
Getting
Started, if required).
Memory module cover
Screw
Removing the memory module cover
Slot A
Seating the memory module
Turning off the power
section in Chapter 6, Power, if required).
section in
Slot B
User's Manual
Advertisement
Table of Contents
