How To Assemble The Chute Deflector; How To Set The Length Of The Cables - Craftsman 536.881851 Operator's Manual

8,5 horsepower electric start 27" dual stage
Table of Contents

Advertisement

Available languages

Available languages

NOTE:
If the cables have become dis-
connected, connect cables as shown in
Figure 7.
Traction Drive Cable
Auger Drive Cable
HOW TO ASSEMBLE THE CHUTE DEFLECTOR
1. Remove the carriage bolt. See
Figure 8.
2. Raise the chute deflector into op-
erating position.
3. Fasten chute deflector to flange
with carriage bolt, Make sure to
installwith head of carriage bolt on
the inside of the flange.
4. Fasten with washer and Iocknut.
5. 13ghten Iocknut securely.
NOTE: Make sure all carriage
bolts in flange are tight. DO NOT
OVERTIGHTEN,
Nut
Figure 7
Chute Deflector
Operating_
Position
Carriage Bolt
Flange
Figure 8
HOW TO SET THE SKID HEIGHT
Your snow thrower is equipped with
height adjust skids on the outside of the
auger housing. To adjust the skid
height for different conditions, see To
Adjust Skid Height paragraph in the
Service And Adjustment
section.
HOW TO SET THE LENGTH OF THE CABLES
The cables were adjusted at the factory
and no adjustments should be neces-
sary. However, after the handles are put
in the operating position, the cables can
be too tight or too loose. If an adjust-
ment is necessary, see =How To Check
And Adjust The Cables" in the Service
And Adjustment section.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents