Tools Required For Assembly - Craftsman 536.886141 Instructions Manual

1- Screw, 5/16-18 x 2 In.
3 - Carriage Bolts, 5116-18x1.00 In.
Parts packed separately in carton (not shown full size)
I - Snow Chute Assembly
2- Ignition Keys
(Attached to engine in plastic bag)
1 - container 5W30 oil
1 - Crank Assembly
CAUTION: Always wear safety
glasses or eye shields while assembling
snow thrower.
TOOLS REQUIRED FOR ASSEMBLY
1 - Knife to cut carton and plastic ties
2 - 112 inch wrenches (or adjustable
wrenches)
2 - 9/!6 inch wrenches (or adjustable
wrenches)
2 - 3/4 inch wrenches (or adjustable
wrenches)
1 - Pliers (to spread cotter pin)
1 - Measuring tape or ruler
The figure below shows the snow thrower in
the shipping carton.
The figure below shows the snow thrower
completely assembled.
References to the right or left hand side
of the snow thrower are from the viewpoint
of the operator's position behind the unit.
Auger driv_ lever
drive lever
cable
assembly
Shifter
lever
Lower handl
Clutch
Upper
handle
assembly
Height
adjust
skids
5