To Throw Snow; To Control Snow Discharge - Craftsman 536.886141 Instructions Manual

The operation of any snow thrower can re-
sult in foreign objects being thrown into the
eyes, which can result in severe eye dam-
age_ Always wear safety glasses or eye
shields while operating the snow thrower.
We recommend standard safety glasses or
a wide vision safety mask for over your
glasses, available at Craftsman Retail
Stores or Service Centers°
CAUTION: Read owner's manual
before operating machine. Never direct
discharge toward bystanders. Release the
auger control bar and stop the engine
before unclogging discharge chute or auger
housing and before leaving the machine.
HOW TO USE YOUR SNOW
THROWER
TO STOP ;','OUR SNOW THROWER
• To stop throwing snow, release the auger
drive lever (see third figure on this page).
• To stop the wheels, release the traction
drive lever (see third figure on this page).
o To stop the engine, push the throttle con-
trol lever to off and pull out (DO NOT
TURN) the ignition key, see figure below.
Pdme! button Starter Button
Ignition
key\
Choke
control starter
Throttle handle
TO CONTROL SNOW DISCHARGE
Turn the crank assembly to set the direc-
tion of the snow throwing.
Loosen the tee knob on the chute deflec-
tor and move the deflector to set the
distance. Move the deflector (UP) for
more distance, (DOWN) for less distance.
Then tighten the tee knob, see figure be-
low.
Tee knob
TO MOVE FORWARD AND
BACKWARD
o To shift, release the traction drive lever
and move the speed shifter lever to the
speed you desire. Ground speed is deter-
mined by snow conditions. Select the
speed you desire by moving the speed
shifter lever into the appropriate area on
the speed selector.
Speeds 1, 2 - Wet, Heavy, Extra Deep
Speed 3 - Light
Speed 4 - Very Light
Speeds 5, 6 - Transport only
° Engage the traction drive lever as shown
in figure below, left hand. As the snow
thrower starts to move, maintain a firm
hold on the handles, and guide the snow
thrower along the clearing path. Do not at-
tempt to push the snow thrower.
= To move the snow thrower backward,
move the speed shifter lever into first or
second reverse and engage the traction
drive lever (left hand).
IMPORTANT: Never move the speed shifter
lever while the traction lever is down.
TO THROW SNOW
Push down the auger clutch lever, see
figure below.
Release to stop throwing snow.
Traction Clutch Lever
On
Lef hand \\
Auger Clutch Lever
Off ..... _ _ ..... _ ,_Off
/ Right hand
TO USE WHEEL LOCKOUT PIN
• The left hand wheel is secured to the axle
with a klick pin see figure below. This unit
was shipped with this klick pin in the
locked position (klick pin through hole
in wheel).
Klick Pin
Locked
Position
10
2-Wheel Drive