Beko 60081474CHD1 User Manual page 60

Problem
Too much foam
forms inside the
product. (**)
Foam is overflowing
from the detergent
drawer.
Laundry remains
wet at the end of
the programme. (*)
(*) The product does not switch to spinning step when the laundry is not evenly
distributed in the drum to prevent any damage to the product and to its surrounding
environment. Laundry should be rearranged and re-spun.
(**) Regular drum cleaning is not applied. Clean the drum regularly.
• If you cannot eliminate the problem although you follow
the instructions in this section, consult your dealer
or the Authorized Service Agent. Never try to repair a
nonfunctional product yourself.
CAUTION!
EN / 60
Cause
Improper detergents for the
washing machine is used.
Excessive amount of
detergent is used.
Detergent was stored under
improper conditions.
Some meshed laundry such
as tulle may foam too much
because of their texture.
Detergent was put in the
wrong compartment.
Too much detergent is used.
Excessive foam has occurred
and automatic foam
absorption system has been
activated due to too much
detergent usage.
Solution
• Use detergents appropriate for the
washing machine.
• Use only sufficient amount of detergent.
• Store detergent in a closed and dry
location. Do not store in excessively hot
places.
• Use smaller amounts of detergent for
this type of item.
• Put the detergent in the correct
compartment.
• Mix 1 tablespoonful softener and ½
l water and pour into the main wash
compartment of the detergent drawer.
• Put detergent into the product suitable
for the programmes and maximum loads
indicated in the "Programme table".
When you use additional chemicals (stain
removers, bleaches and etc), reduce the
amount of detergent.
• Use recommended amount of detergent.
Washing Machine / User's Manual