Troubleshooting - SATA SATAjet 3000 K RP/HVLP Operating Instructions Manual

Hide thumbs Also See for SATAjet 3000 K RP/HVLP:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 389
Operating Instructions SATAjet 3000 K RP/HVLP
US
After installation, please adjust material flow according to chapter 7.2.
• Check if locking screw [1-9] has been firmly tightened! Air micrometer
[1-8] could shoot out from the spray gun uncontrolled!
9.6. Replacing the Spindle of Round/Flat Spray
Control
It needs to be replaced when air leaks from the control knob or when flat/
round control does not work. After disassembly, apply some sealant on
thread of the spindle, e.g. Loctite 242 [11-4].

10. Troubleshooting

Malfunction
Fluttering/spitting
spray fan or air bub-
bles appearing in the
gravity flow cup
Spray pattern is too
small, crooked, lop-sid-
ed or splitting
No function of round/
flat spray control - con-
trol knob can still be
turned
398
Warning!
Steps: [11-1], [11-2], [11-3], [11-4]
Cause
Fluid tip has not been
properly tightened
Air distribution ring is
damaged or clogged.
Clogged air cap drill-
ings
Damaged fluid tip (fluid
tip aperture)
Air distribution ring has
not been positioned in
correct location (pin is
not located in the drill-
ing) or damaged
Corrective action
Tighten fluid tip
[2-1]
with universal
spanner
Replace air distribu-
tion ring, as it will be
damaged during disas-
sembly
Clean air cap, observe
chapter 8
Check if fluid tip is
damaged, replace the
nozzle set, if neces-
sary, chapter 9.1
Replace air distribution
ring making sure it has
been positioned cor-
rectly when inserting it,
chapter 9.2

Advertisement

Table of Contents
loading

Table of Contents