Troubleshooting - SATA SATAjet 2000 LAB HVLP Operating Instructions Manual

Notice!
Use of aggressive cleaning
agents can damage the automat-
ic gun.
→ Do not use aggressive cleaning
agents.
Use only suitable cleaning fluids
for cleaning.
→ Use neutral cleaning agent with
pH-value of 6–8.
→ Do not use acids, alkalis,
bases, paint stripper, unsuitable
regenerates or other aggressive
cleaning agents.
Immersing the automatic gun in
the cleaning fluid can cause cor-
rosion.
→ Do not immerse automatic gun
in cleaning fluid.
Improper cleaning tools can dam-
age the bores and have a nega-
tive effect on the spray pattern.
→ Use only SATA cleaning brush-
es.
→ Never use ultra-sonic cleaning
equipment.

12. Troubleshooting

The troubleshooting chart below
lists malfunctions, causes and rem-
edies.
If it is not possible to rectify a
malfunction with the remedies de-
scribed, send the automatic gun in
to the SATA Service Department.
Operating Instructions for SATA LAB Automatic Guns
(see Chap. 13 for address).
Malfunc-
tion
Spritzstrahl
unruhig
Spritzbild
zu klein,
schräg, ein-
seitig oder
spaltet.
Flat fan
control does
not work.
Cause Correc-
tive ac-
Paint nozzle Retighten
not tight- paint noz-
ened suffi- zle.
ciently.
Air distri- Replace air
bution ring distribution
dirty or ring (see
damaged. Chap. 10.2).
Air nozzle Tighten air
loose. nozzle ring
hand tight.
Space Clean in-
between air termediate
and paint space.
nozzle dirty.
Nozzle set Clean noz-
dirty. zle set.
Damaged Replace
nozzle set nozzle set
(see Chap.
10.1).
Bore in Clean air
air nozzle nozzle (see
clogged Chap. 10.1).
with paint.
Paint nozzle Check paint
tip (paint nozzle tip
nozzle in) for damage.
damaged. Replace
nozzle set,
if necessary
(see Chap.
10.1).
Air distri- Position air
bution ring distribution
incorrectly ring cor-
positioned. rectly (see
Chap. 10.2).
Air distri- Replace air
bution ring distribution
damaged. ring (see
Chap. 10.2).
US
431