Table of Contents
Advertisement
Installation -
Disassemble the camera
Before installing your camera, you have to read the following cautions.
1. You have to check whether the location can bear five times of the weight of your camera.
2. Don't let the cable to be caught in improper place or the electric line cover to be damaged.
Otherwise it may cause a breakdown or fire.
3. When installing your camera, don't allow any person to approach the installation site. If you have any valuable things under the
place, move them away.
Protective
Film
Detach the dome cover by torx wrench provided from
1
bottom case and remove the protective film before
installing the camera.
Be sure to assemble the dome cover and bottom case to
match the case outline.
Reset to the Factory Default
Press the reset button for 5 seconds to return the setup
to the factory default.
Warning :
If you press the 'Reset' button, you will lose all setting
data. If needed, please, make a note for further installation.
Desi-Pak (Moisture Absorber)
Remove the existing Desi-Pak and insert the new one
belonging in accessory between Module and Base at the
end of the installation.
Warning :
The inserted Desi-Pak may fall during installaion.
8
Reset Button
Advertisement
Table of Contents
