Denon UPO-250 Operating Instructions Manual page 5

[4] CONNECTIONS
These jacks are for connecting the exclusive surround
processor. For instructions on connections, refer to the
surround processor's manual. FM antenna
Refer to Page 4.
las
233
vif
AM foop antenna
Keep the FM and AM antenna wires away from the system
connector wires to prevent noise from entering the
antennas.
COAXIAL,
DIGITAL tN
a
San
EH UUUOUUU UU
AVA eam of Owe Gécrema
(MM cartridge)
NOTE:
This system includes digital circuitry which may interfere
with the colors on a TV. Should this occur, switch off the
power of the unused component(s).
USC-250
(Left channe}} (Right channel)
Speaker system connections
Connect the speaker system for the left
channel (the feft side as seen from the
front) to the L terminals, and the speaker
system for the right channel to the R
terminals.
Pradecnern Pare AC OUTLET
AC 240 V 50 ue. (for U.K. mode!)
Always connect the amplifier's (UPO-250) power card to this AC
(Plug into a power outlet.) outiet.
e@ SWITCHED (total capacity of 370 W)
The power of this outlet is switched on and off with the tuner's
power switch.
Plug the power amplifier's power cord into this outlet.
e UNSWITCHED {total capacity — 110W)
The power is supplied to these outlets regardiess of whether
or not the tuner's power switch is turned on or off.
Plug the power cords of the CD player and cassette deck into
these outlets.
Power cord
{for U.K. model)
MONO OUT jack
Jack for connecting a subwoofer (super
woofer) with built-in amplifier.
Do not plug the power cord into the outlet until all connections have been
completed. Connect properly as illustrated in the diagram.
© Check the left and right channels, then properly connect the left speaker's
terminals to the amplifier's L terminals and the right speaker's terminals
to the amplifier's R terminals.
e Insert the plugs securely. Incomplete connections can cause noise.
@ When the power cord has been disconnected from the power outlet, wait
about 5 seconds before plugging it back in.
@ Use the AC OUTLET to plug in the amplifier CD and Cassette deck. Never
use it for other appliances, such as halr driers, etc.
e Note that grouping connection cords (pin-plug cords) together with
power cords or setting them near power transformers can cause hum or
other noise.
e Note that if the input jacks selected with the FUNCTION button are open (if
a component is not connected), there might be leakage of the reproduced
sound of a component connected to another set of input jacks.
NOTE:
System operation is not possible and the power cannot be turned on and off unless ail system connector cords
and pin-plug cords are connected.
G)
m
z
m
0
>
-
n
m
i?)
ra
Oo
Zz