Product Overview; Controls - Toro 03956 Operator's Manual

Product Overview

1. Engine hood
2. Seat
3. Control arm
4. Steering wheel

Controls

1. Key switch
2. Cruise control
3. Lower mow/raise control
lever
4. PTO switch
Figure 38
5. Seat adjustments
6. Front cutting units
7. Rear cutting units
Figure 39
5. Headlight switch
6. Parking brake switch
7. InfoCenter
1. Traction pedal
Automotive-Style Throttle
g216864
Note:
This machine does not have a lever or switch
to control the engine speed.
When the PTO is engaged to start spinning the
reels, the machine automatically changes the engine
speed to high idle and stays there until the reels are
disengaged.
When the PTO is not engaged, the machine's throttle
is dependent on the position of the traction pedal, just
like the throttle on a car.
Traction Pedal
The traction pedal
and reverse operation. Press the top of the pedal to
move forward and the bottom to move backward.
Note:
In emergency braking situations, remove
your foot from the traction pedal and then pivot the
parking-brake switch forward
Cruise-Control Switch
g383547
The cruise-control switch has 3 positions: O
and E .
NGAGE
To turn on the cruise control, pivot the switch to the
middle position.
To engage the cruise control, briefly pivot the switch
forward. When cruise control is engaged, the cruise
control screen will appear on the InfoCenter. Use the
InfoCenter buttons to adjust the cruise control speed
in 0.8 km/h (0.5 mph) increments.
Tilt-Steering Pedal
To tilt the steering wheel towards you, press the foot
pedal (Figure 40) down, pull the steering tower toward
you to the most comfortable position, and release the
pedal.
22
Figure 40
2. Tilt steering pedal
(Figure 40) controls the forward
(Figure 40).
g383839
, O ,
FF N