Grid Connection - Redx RX Series User Manual

As shown in figure 5-7.2.2 an arrow indicating the direction of the CT, pass cable
through the hole of the CT then lock the CT.
The RS-485 communication connection is shown as follows:
1
11
21
Figure 5.7.2.3 - RX-7000HY/5000HY Communication connector 485 pins
5.7.3 Connection of DRM0 Terminal (Australia Only)
When RX-7000HY/5000HY is installed in some states in Australia, the DRMS terminal
needs to be connected. The connection method is as follows:
1
11
21
Figure 5.7.3 - RX-7000HY/5000HY Communication connector DRM pins

5.8 Grid Connection

Requirements
1.Install an AC circuit breaker between the inverter and the grid, before connecting the
system to the grid.
2.Grid voltage and grid frequency should be within the allowable range of inverter
operation.
Rev 20230601
Pin
10
18
19
20
30
20
Pin
10
16
20
17
30
RX - 7000HY/5000HY
Group
B6
B5
B4
Group
B8
B7
Page 26 of 41
Pin
GND
485C-
485C+
Pin
DRM0-
DRM0+