Advertisement
Quick Links
Please read the instructions completely before beginning the installation.
Athena Collection
Model Number: 3470HO
Flush both supply lines before installation, then shut off both supply lines.
Minimum hole size for the spout and handle trim is 1-1/4" and maximum of 1-1/2"
VACUUM BREAKER INSTALLATION
1
- Remove complete trim from vacuum breaker valve.
2
- Install bidet elbow into threaded outlet.
- Insert gasket into bidet wye and thread onto bottom of vacuum
3
breaker valve.
- Remove black plastic lock nut, nylon slip washer and one
4
black self-seating china seal.
- Insert diverter valve body up from below and reinstall black
5
self-seating china seal, nylon slip washer and black plastic lock
nut being sure to tighten firmly by hand.
- Thread trim cylinder onto vacuum breaker valve and tighten
6
firmly. Place handle on top and secure with brass screw. Insert
handle cap with arrow facing towards front of bidet.
The measurements shown are for reference only. Products and specifications shown are subject to change without notice.
www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681
ATHENA & PIANA COLLECTIONS
Piana Collection
Model Number: 4570HN
Rev 06/2016
Installation Instruction
Bidet Fitting
Handle Cap
Screw
Handle
Trim Cylinder
Black plastic lock nut
White Nylon Slip Washer
Black Soft Seating China Seals
Black Soft Seating China Seals
1/5
Advertisement
Related Manuals for Santec Athena 3470HO
Summary of Contents for Santec Athena 3470HO
- Page 1 Rev 06/2016 Installation Instruction ATHENA & PIANA COLLECTIONS Bidet Fitting Please read the instructions completely before beginning the installation. Athena Collection Piana Collection Model Number: 3470HO Model Number: 4570HN Flush both supply lines before installation, then shut off both supply lines. Minimum hole size for the spout and handle trim is 1-1/4”...
- Page 2 HANDLE TRIM INSTALLATION DO NOT DISASSEMBLE HANDLE ASSEMBLY - DROP-IN VALVES - Remove the valve body mounting hardware from valve body. Hot valve assembly “Red” to be mounted on left. Cold valve assembly “Blue” to be mounted on right. - Apply a ring of silicone caulking around the handle hole on bidet top.
-
Page 3: Complete Assembly
COMPLETE ASSEMBLY INLET HOSE INLET HOSE SPECIFICATION SHEETS 8 " 4 " 4 " 8 " 5" 8 " 8 " 2" The measurements shown are for reference only. Products and specifications shown are subject to change without notice. www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681... - Page 4 Doing so may ruin your faucet finish and/or void the warranty. Thank you for making SANTEC a part of your lifestyle and luxury spa experience. Our products have been created as works of enduring quality and sophisticated design.
- Page 5 SANTEC reserves the product components of the covered product will be repaired, refinished, or replaced at the sole discretion of SANTEC. SANTEC reserves the right to examine any product claimed defective prior to any warranty claim being accepted or processed, at its sole discretion. This warranty gives you specific legal rights and you may have other rights which may vary from state to state.