Alpine collection
pressure balanced tub and shower with “dd” handle (4 pages)
Summary of Contents for Santec ENZO COLLECTIONS 3670EN
Page 1
Rev 06/2016 Installation Instruction ENZO COLLECTIONS Bidet Fitting Please read the instructions completely before beginning the installation. Enzo Collection Model Number: 3670EN Flush both supply lines before installation, then shut off both supply lines. Minimum hole size for the spout and handle trim is 1-1/4” and maximum of 1-1/2” VACUUM BREAKER INSTALLATION - Remove complete trim from vacuum breaker valve.
Page 2
HANDLE TRIM INSTALLATION DO NOT DISASSEMBLE HANDLE ASSEMBLY - DROP-IN VALVES - Remove the valve body mounting hardware from valve body. Hot valve assembly “Red” to be mounted on left. Cold valve assembly “Blue” to be mounted on right. - Apply a ring of silicone caulking around the handle hole on bidet top.
Page 3
COMPLETE ASSEMBLY INLET HOSE INLET HOSE SPECIFICATION SHEETS The measurements shown are for reference only. Products and specifications shown are subject to change without notice. www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681...
Page 4
Doing so may ruin your faucet finish and/or void the warranty. Thank you for making SANTEC a part of your lifestyle and luxury spa experience. Our products have been created as works of enduring quality and sophisticated design.
Page 5
SANTEC reserves the product components of the covered product will be repaired, refinished, or replaced at the sole discretion of SANTEC. SANTEC reserves the right to examine any product claimed defective prior to any warranty claim being accepted or processed, at its sole discretion. This warranty gives you specific legal rights and you may have other rights which may vary from state to state.
Need help?
Do you have a question about the ENZO COLLECTIONS 3670EN and is the answer not in the manual?
Questions and answers