Husqvarna PP492HF Workshop Manual page 24

7 7
1
3
5
24 24
SERVICE AND MAINTENANCE SERVICE AND MAINTENANCE
2
4
Adjust the saw carriage
As the saw wears, after a number
of hours working, it can be
a good idea to ensure that the saw
sits firmly in the saw
carriage and rail� If not, the handle
probably needs adjusting:
1� Loosen the two stop screws with a
3 mm allen key�
2� Turn the two excenter sleeves with
a 8 mm allen key until the shaft is
tight and parallell to the saw unit�
3� Tighten the two stop screws with a
3 mm allen key�
4� Remove the saw head from
the carriage� Doublecheck that
the two Allen lock-screws are
tightened when the saw head is
off�
5� Make sure the locking handle is
properly adjusted by open and
close and see that the spring
loaded lock is in locked position�
Then secure the locked handle
with the locking pin�