Adjust Play On Feed Motor Gearbox - Husqvarna PP492HF Workshop Manual

8
10
1
3
REPAIR INSTRUCTIONS
9
2
8� Insert a bolt in the bearing�
9� Grab the bolt and pull the
bearings and washers out�
10� Remove the needle bearing�
Adjust play on Feed Motor
Gearbox
First see: Remove Feed Motor
Gearbox (p. 102)
1� Fasten the gearbox with the four
bolts�
2� Turn the engine over and place
the washers and bearings on the
bottom of the gearbox�
3� Measure distance A and distance
B using a calliper�
The difference between A and
B should be between 0 and 0�05
mm� The distance can be adjusted
by adding or removing shims�
10.3
1 0 3