TechniSat DIGITRADIO 380 CD IR Manual page 52

- Replace batteries that are losing power in good time.
- Leaking batteries can cause damage to the remote control.
- If the device is not to be used for a prolonged period, remove the batteries
from the remote control.
- Important instructions for disposal: Batteries may contain toxic substances
that are hazardous to the environment. Therefore, it is imperative to dispose
of the batteries according to the legal provisions in force. Never dispose of
batteries in normal household waste.
6.4 General device functionality
Settings and functions can be carried out both using the buttons on the device and
with the remote control. The description of the operation in this instruction manual
refers to the buttons on the remote control.
6.4.1 Switching on the device
> You can use the On/Standby
(14) button on the remote control to switch the device on or back to standby.
After switching on for the first time, you can launch the set-up wizard
(Section 17.8). Here you can set the date and time either via DAB/FM, Internet
or have no update (manual). The device will then attempt to establish a
connection to a WiFi network. To do so, select the corresponding WiFi
network and, if required, enter the WiFi password using the remote control.
6.4.2 Switching off the device
> You can use the On/Standby
on the remote control to switch the device on or back to standby. The date
and time are shown in the display.
6.4.3 Operating the device with the remote control
With the infrared remote control you can operate the most important device
functions from the comfort of your armchair. When operating the device with the
remote control, please take into account the following points:
> Point the remote control at the front of the device.
> Visual contact between the transmitter and the receiver must be guaranteed.
> If the range of the remote control reduces, replace the batteries.
The maximum range is approximately 5 metres from the front of the device.
52
(3) button on the device or the On/Standby
(3) button on the device or On/Standby (14)