Canon EOS REBEL T6 W Instruction Manual page 63

Configuring Settings to Use Web Services
Start EOS Utility on the computer, log in to CANON iMAGE GATEWAY,
then configure the camera's settings to enable access to Web services.
For details, refer to the EOS Utility Instruction Manual. For how to
obtain EOS Utility and the EOS Utility Instruction Manual, refer to
the Camera Instruction Manual.
The general procedure for sending images to a Web service is as
follows.
1
Install EOS Utility on a computer.
If you have already installed it, proceed to step 2.
2
Access Canon Web site from the computer and sign up
as a CANON iMAGE GATEWAY member (free of charge).
If you are already a member, proceed to step 3.
3
Connect the camera and computer with an interface
cable.
Before connection, set [53: Wi-Fi/NFC] to [Disable].
4
Start EOS Utility on the computer, log in to CANON
iMAGE GATEWAY, then configure the camera's settings
to enable access to Web services.
For details, refer to the EOS Utility Instruction Manual.
5
Disconnect the interface cable.
6
Connect the camera to a Wi-Fi access point (p.64).
7
Send images to a Web service registered on the camera
(p.76).
You can share images with your family and friends by sending
images from the camera to a Web service registered on the camera
or by sending links to the online albums.
Preparation for Web Services
63