Renault Captur User Manual page 140

STARTING, STOPPING THE ENGINE: vehicle with card
7
6
Remote engine start-up
This function allows remote starting of
the engine.
Initialisation
If the vehicle is so equipped, press
the unlocking button 7 then press the
remote start button twice in succession
for about 2 seconds each time 6. The
time between the two presses must be
less than 5 seconds. The hazard warn-
ing lights will come on continuously for
3 seconds to confirm the system reset.
2.10
Note: once the function has been acti-
vated, it cannot be deactivated.
We advise you to contact an Approved
Dealer.
Operation
8
To start the engine remotely, press
the locking button 8 then within an-
other 2 seconds, press the remote start
button 6 for approximately 2 seconds.
The hazard lights come on continu-
ously for approximately 3 seconds and
the engine starts.
The engine will run for 5 minutes. Once
the engine is running, you can add an-
other 5 minutes by pressing the 8 lock-
ing button again, then the remote start
button 6. The hazard lights come on
continuously for 3 seconds to confirm
that the function has been prolonged.
(5/6)
9
This function also lets you programme
the engine to start, in order to heat or
ventilate the passenger compartment
up to 24 hours before using the vehicle.
Depending on the vehicle, configuration
and programming are carried out using
the multimedia display 9, for more infor-
mation please refer to the multimedia
instructions.