Control Panel - Supermicro SuperServer 220BT-DNTR User Manual

Control Panel

Information LED
Feature Description
Node Label Label with the name of the node that is connected to the control panel.
The main power switch applies or removes primary power from the power supply to the
Power Button
server but maintains standby power.
NIC LED Indicates network activity on the LAN when flashing.
Information LED Universal information LED (see table below for details).
The BMC reset button resets the BMC firmware when pressed. The unit identification (UID)
BMC Button/UID
button turns on or off the blue light function of the Information LED and a blue LED on the
LED
rear of the chassis. These are used to locate the server in large racks and server banks.
Status
Continuously on and red
Blinking red (1Hz)
Blinking red (0.25Hz)
Solid blue
Blinking blue
Node Label
NIC LED
Figure 1-2. Control Panel
Control Panel Features
Information LED
Description
An overheat condition has occurred.
Fan failure, check for an inoperative fan.
Power failure, check for a non-operational power supply.
Local UID has been activated. Use this function to locate the server in a rackmount
environment.
Remote UID is on. Use this function to identify the server from a remote location.
11
Chapter 1: Introduction
Power Button
BMC Button/UID LED