Table of Contents
Advertisement
Stopper
pin
● Buttonhole clamping plate
Clamping plate
52
Ripper
Eyelet
punch
6
Unplug the sensor pin after sewing.
7
Opening the buttonhole using a ripper.
[double bartack]
Pierce a stopper pin at the bartack and open the but-
tonhole with a ripper. Be careful not to cut the stitches.
[Keyhole buttonhole]
Place a cardboard under the buttonhole and make a
hole with the eyelet punch. Then pierce a stopper pin
at the bartack and open the buttonhole with a ripper.
Caution
It will be easier to sew buttonholes on the thin fabrics
and/or near the overlapped sections, if the clamping
plate is used.
1. Attach the buttonhole presser foot
A
to the presser foot holder, with the
clamping plate together.
2. Place the fabric between the presser
foot and the clamping plate.
* You can remove the clamping plate by holding
Turn off the power when
setting the clamping plate.
.
A
Advertisement
Table of Contents
