Table of Contents
Advertisement
NLSet up and connect
Zeolite drying is therefore very
energy-saving.
Tip:To ensure that the zeolite drying
works properly, do not place any
dishes directly in front of the suction
opening and outlet opening of the
zeolite reservoir.
Do not place temperature-sensitive
dishes directly in front of the blow-out
opening of the zeolite reservoir.
→ "Device", page 14
3.4 autoOpen Dry
The appliance door opens
automatically during the drying phase.
As a result, a particularly economical
drying is achieved.
For optimum drying results, it is
advisable to wait for the end of the
program before removing the dishes.
The program is finished when
"0h:00m" is shown on the display.
If the automatic door opening is
deactivated, the energy consumption
increases and the drying phase is
usually shortened.
→ "Overview of basic settings",
page 36
12
4 Set up and connect
For correct use, connect the device to
electricity and water in a professional
manner. Observe the required criteria
and the installation instructions.
4.1 Scope of Delivery
After unpacking, check all parts for
transport damage and the
completeness of the delivery.
For complaints, please contact the
store where you bought the device
or our customer service.
Remark:The device has been checked
at the factory for correct operation.
This may leave water stains on the
device. The water stains disappear
after the first wash cycle.
The delivery consists of:
¡Dishwasher
¡Instructions
¡Assembly instructions
¡Other documents containing information
tie
¡Mounting material
¡Salt filling aid funnel
¡Connection cord
¡Quick guide
4.2 Setting up and connecting
the device
You can install your substructure or
built-in appliance in the kitchen unit
between wooden and plastic walls. If
you subsequently set up the device as
a free-standing device, you must
secure the device against tipping over,
e.g. by screwing it to the wall or
installing it under
Advertisement
Table of Contents
