Table Of Contents - Toro Power Max Heavy Duty 928 OHXE Operator's Manual

Important: If you are using this machine above 1500 m
(5,000 ft) for a continuous period, ensure that the High
Altitude Kit has been installed so that the engine meets
CARB/EPA emission regulations. The High Altitude
Kit increases engine performance while preventing
spark-plug fouling, hard starting, and increased
emissions. Once you have installed the kit, attach
the high-altitude label next to the serial decal on the
machine. Contact any Authorized Toro Service Dealer
to obtain the proper High Altitude Kit and high-altitude
label for your machine. To locate a dealer convenient to
you, access our website at www.Toro.com or contact our
Toro Customer Care Department at the number(s) listed
in your Emission Control Warranty Statement.
Remove the kit from the engine and restore the engine
to its original factory configuration when running the
engine under 1500 m (5,000 ft). Do not operate an engine
that has been converted for high-altitude use at lower
altitudes; otherwise, you could overheat and damage
the engine.
If you are unsure whether or not your machine has been
converted for high-altitude use, look for the following
label (Figure 3).
This spark ignition system complies with Canadian ICES-002.
Contents
Introduction .................................................................. 1
Safety ........................................................................... 3
Safety and Instructional Decals ................................. 3
Setup ............................................................................ 5
1 Installing the Upper Handle.................................... 6
2 Installing the Wheel-Clutch-Cable Ends ................... 6
3 Installing the Traction-Control Linkage.................... 7
4 Installing the Chute-Control Rod ............................ 8
5 Connecting the Headlight and Handwarmer Wire
to the Engine ...................................................... 9
6 Checking the Engine-Oil Level ..............................10
7 Checking the Tire Pressure ....................................10
8 Checking the Skids and Scraper ..............................10
9 Checking the Operation of the Traction
Drive ................................................................10
Product Overview .........................................................11
Operation ....................................................................12
Before Operation ......................................................12
Safety....................................................................12
Figure 3
Filling the Fuel Tank ...............................................12
During Operation .....................................................12
Safety....................................................................12
Starting the Engine .................................................13
Shutting Off the Engine ..........................................15
Operating the Handwarmers....................................16
Operating the Traction Drive ...................................16
Using the Wheel-Clutch Levers ................................16
Operating the Speed Selector ...................................17
Operating the Auger/Impeller Drive.........................17
Operating the Quick Stick®.....................................17
Unclogging the Discharge Chute ..............................18
Operating Tips ......................................................18
After Operation ........................................................19
Safety....................................................................19
Preventing Freeze-up after Use.................................19
Maintenance .................................................................20
Recommended Maintenance Schedule(s) ......................20
Maintenance Safety.................................................20
Preparing for Maintenance.......................................20
Checking the Engine-Oil Level.................................21
Checking and Adjusting the Skids and
Scraper ..............................................................21
Checking and Adjusting the Traction Cable ................21
Checking and Adjusting the Auger/Impeller
Cable ................................................................22
Checking the Auger-Gearbox-Oil Level .....................23
Changing the Engine Oil .........................................23
Lubricating the Hex Shaft ........................................24
Replacing the Spark Plug .........................................24
Adjusting the Discharge-Chute Latch ........................25
Replacing the Drive Belts.........................................26
Replacing the Headlight Bulb ...................................26
Storage ........................................................................27
Preparing the Machine for Storage ............................27
Removing the Machine from Storage.........................27
Troubleshooting ...........................................................28
2