Installation
Oven Assembly
CONVEYOR TUNNEL EXTENSIONS
1. Install the two conveyor tunnel extensions on
each end of the oven.
Figure 14
CONVEYOR BELT TENSIONER
NOTE: Each tensioner installs between the idle
end of the conveyor (the side opposite the
drive) and the oven's body side.
1. Compress the tensioner assembly spring by
hand.
2. Engage the tensioner pin with the hole in the
body side.
3. Lift to engage the pin on the opposite side with
the conveyor.
Figure 15
CRUMB PANS
1. Install the crumb pans under each end of the
conveyor.
REMOTE COMPUTER CONTROL
1. Drill the mounting holes for the cooking com-
puter support base.
2. Mount the support base and cable support
bracket to the wall.
3. Stack the cooking computer(s) on the support
base. Connect the cables at the rear of the
controller.
4. Secure the cables to the cable clamp support
bracket and to the rear of the oven using cable
clamps and screws.
NOTE: DO
clamps. Damage to the wires may oc-
cure causing the computer to fail.
Cooking Computer
Cooking Computer
Support Base
10
Figure 16
NOT
overtighten
the cable
Cable Clamp
Support Bracket
Figure 17