Conveyor Belt - Blodgett MT2136E/AB Installation Operation & Maintenance

Installation
Oven Assembly

CONVEYOR BELT

NOTE: Conveyor belt is shipped installed on
some units.
Be sure to install the belt from left to right. The con-
veyor belt has loops on both sides. The loops must
travel backwards on the conveyor support. See
Figure 7.
Figure 7
Unless specified otherwise, conveyor travel is fac-
tory set for left to right operation when facing the
front of the oven. To change direction:
Reverse the polarity of the drive motor. Inter-
D
change the black and white motor leads at the
D.C. controller located in the control panel.
Install the conveyor belt from the left side of the
D
oven.
To thread the conveyor belt
1. Start from the right hand side of the oven, low-
er level first. Unroll the belt as shown in
Figure 8, otherwise the belt will be upside
down. Leave about one foot hanging out on
the left side
NOTE: If belt travel is from left to right, start
2. Take the remainder of the belt, loop it around
Belt Top
the right shaft. Push through on the upper lev-
el.
3. The two ends of the belt should be approxi-
mately 6-9 inches past the left shaft on the up-
per level of the belt support. Right shaft if right
to left travel is required.
8
from the left side of the oven.
Figure 8
Figure 9