Scan Optics SO-5000 User Manual page 80

SO-5000 Ophthalmic Microscope
3. Tighten the pillar safety clamp at a point midway up the vertical pillar. Refer to figure 4 (A).
4. Remove the articulated arm assembly from the case, and place it on the vertical pillar. Make
sure that the arm assembly rests against the pillar safety clamp. Refer to figure 4 (B).
5. Remove the microscope assembly from the case and locate the microscope assembly in the
end of the arm assembly. Tighten the knob underneath the end of the arm to secure the
microscope in the collet. Refer to figure 4 (C).
7. Pass the lamphouse cable through the cable clips ring on the arm assembly and attach the plug
to the connector on the top of the pillar. This will ensure the cable does not obstruct the
surgeon or come into contact with the sterile area.
ISSUE NUMBER: 5.0
DATE: 11/04/02
A
C
Figure 4 Assembling the microscope
SUPERSEDES: 4.0
DATE: 22/05/01
User Manual
WRITTEN BY:
DATE: 22/08/97
Page 8 of 36
B
D
RJK CHECKED BY:
DATE: 22/08/97
NW