Nomenclature; Front Panel; Rear Panel - Omron NSA Series User Manual

2-1

Nomenclature

2-1-1 Front Panel

2-1 Nomenclature
2-1-1 Front Panel
2

2-1-2 Rear Panel

Loosen these three screws to remove the Side Cover.
Functional Ground Terminal
This terminal prevents noise-induced
This indicator is disabled during normal operation and enabled
2-2
POWER Indicator
Green lamp is lit when the power is ON.
Display Area
The entire display area is a touch panel and
input device.
Side Cover Fastening Screws
malfunctions.
DIAG Indicator
only during RAS Board self-diagnosis.
ERR Indicator
The red lamp is lit when a RAS failure occurs.
Side Cover
View with Side
Remove the Cover to install a PCI
Cover removed
Board or to set the DIP switch.
UPS Power Interrupt Signal Connector
This connector is used for the power interrupt signal from the UPS.
BATLOW Indicator
The red lamp is lit when the RAS Board backup battery is exhausted.
RUN Indicator
The red lamp is flashing while the RAS Board is operating.
PCI Board Connector
Use this Connector to install a PCI
Board.
RAS Board
Use this Board to monitor the
status of the Unit.