Gateway E-3600 System Manual page 138

European Union
The following information is only applicable to systems labeled with the CE mark
European directives
This Information Technology Equipment has been tested and found to comply with the following
European directives:
I EMC Directive 89/336/EEC with amending directives 92/31/EEC & 93/68/EEC as per
- EN 55022:1998 Class B
- EN 61000-3-2:1995
- EN 61000-3-3:1995
- EN 55024:1998
I Low Voltage Directive (Safety) 73/23/EEC as per EN 60950:1992(A1/A2/A3/A4/A11)
I Radio and Telecom Terminal Equipment Directive 199/5/EC as per CTR21:1998 (if fitted with
a modem device)
European telecommunication information (for products fitted with EU-approved
modems)
Marking by the symbol
Terminal Equipment Directive 1999/5/EC. Such marking is indicative that this equipment meets
or exceeds the following technical standards:
CTR 21 (1998) - Attachment requirements for pan-European approval for connection to the
analogue Public Switched Telephone Networks (PSTNs) of TE (excluding TE supporting voice
telephony services) in which network addressing, if provided, is by means of Dual Tone
Multi-Frequency (DTMF) signaling.
Warning
This equipment has been approved to Council Decision 98/482/EEC—"CTR 21" for Pan-European
single terminal connection to the Public Switched Telephone Network (PSTN). However, due to
differences between the individual PSTNs provided in different countries, the approval does not,
of itself, give an unconditional assurance of successful operation on every PSTN termination
point. In the event of problems, you should contact Gateway Technical Support.
130
Safety, Regulatory, and Legal Information
indicates compliance of this equipment to the Radio and Telecom
Although this equipment can use either loop disconnect
(Pulse) or DTMF (Tone) signaling, only the performance
of the DTMF signaling is subject to regulatory
requirements for correct operation. It is therefore strongly
recommended that the equipment is set to use DTMF
signaling for access to public or private emergency
services. DTMF signaling also provides faster call setup.
.