Table of Contents
Advertisement
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing trimmer bit
NOTICE:
Do not tighten the collet nut without
inserting the bit. The collet cone may break.
Insert the trimmer bit all the way into the collet cone.
Press the shaft lock and tighten the collet nut with the
wrench or tighten the collet nut securely with the two
wrenches. To remove the bit, follow the installation
procedure in reverse.
1
2
► 1 . Shaft lock 2. Loosen 3. Tighten 4. Wrench
5. Collet nut
1
2
► 1 . Wrench 2. Loosen 3. Tighten 4. Collet nut
NOTE: The shaft lock may not return to the original
position when you tighten the collet nut at the instal-
lation of the trimmer bit. The shaft lock returns to the
original position when you start the tool.
1
► 1 . Shaft lock
Installing or removing the trimmer
base
1.
Open the lock lever of the trimmer base, then
3
insert the tool into the trimmer base aligning the groove
on the tool with the protrusion on the trimmer base.
4
5
3
1
► 1 . Lock lever
4
9 ENGLISH
1
Advertisement
Table of Contents
