Table of Contents
Advertisement
Using the straight guide
Optional accessory
1.
Assemble the straight guide with the bolt and the
wing nut.
1
2
► 1 . Bolt 2. Wing nut
2.
Attach the straight guide to the trimmer base with
the clamp screw.
1
► 1 . Clamp screw
3.
Loosen the wing nut on the straight guide and
adjust the distance between the bit and the straight
guide. At the desired distance, tighten the wing nut.
1
► 1 . Wing nut
4.
Move the tool with the straight guide flush with the
side of the workpiece.
If the distance (A) between the side of the workpiece
and the cutting position is too wide for the straight
guide, or if the side of the workpiece is not straight, the
straight guide cannot be used.
In this case, firmly clamp a straight board to the work-
piece and use it as a guide against the trimmer base.
Feed the tool in the direction of the arrow.
A
Using the straight guide for circular work
For circular work, assemble the straight guide as shown
in the figures. The minimum and maximum radius of
circles to be cut (distance between the center of circle
and the center of bit) are as follows:
•
Minimum: 70 mm
•
Maximum: 221 mm
For cutting circles between 70 mm and 121 mm in
radius.
► 1 . Center hole
14 ENGLISH
1
Advertisement
Table of Contents
