Table of Contents
Advertisement
Note: If you are using a docking station or an external power supply, you can insert an
uncharged battery and use the device while the battery charges.
Assuming the default power saving parameters and battery reserve level have not been al-
tered, a battery can be removed for up to 5 minutes without losing data. After 5 minutes the
terminal may reboot.
2.2.2
Removing the Battery Pack
•
If your unit is equipped with a hand or shoulder strap, unhook it from the base of
the battery.
•
Press the two latch buttons at the sides of the compartment simultaneously, and slide the
battery out.
2.2.3
Installing the Battery Pack
•
Slide the charged battery with the contoured plastic facing you into the unit with the
contacts matching position and the guide tabs moving into the corresponding slots at the
base of the compartment. Click both sides of the battery into place.
•
If your computer is equipped with a hand or shoulder strap, re-attach the clip to the slot
at the base of the battery.
Switch the unit on (see "Switching Omnii On and Off" on page 15).
2.3
Switching Omnii On and Off
Follow the instructions below for your Omnii.
Switching Omnii On
•
Press and hold down the [ENTER/Power] key for at least one second.
When the unit is turned off, normally it automatically enters a power-saving, "suspend"
state. When Omnii is switched on from the suspend state, operation resumes within a few
seconds in the screen in which you were working prior to turning the computer off.
Psion Teklogix Omnii Hand-Held Computer User Manual
Chapter 2: Basic Operation
Switching Omnii On and Off
15
Advertisement
Table of Contents
