Table of Contents
Advertisement
hYpeR MeMoRY chAnnel
In standby, press the left or right volume knob will switch the radio work
on hyper channel 1 or hyper channel 2.
duAl wAtch
In standby, hold
key for over 0.5 second to enter Dual Watch mode.
The radio will scan the channel in every 5 seconds. When the radio
receives matching signal, it pause scanning until the signaling disappear.
Repeat above operation to exit Dual watch.
eMeRGencY AlARM
To start emergency alarm, hold the right volume knob until the trans
-ceiver displays ALARM and emit alarm. Re-power on the transceiver to
exit alarm. This transceiver has 4 kind of alarm which can be setup by
programming software.
chAnnel/FRequencY ScAn
F Re q uencY ScAn
In VFO mode, this function is designed to monitor signal of every
communicative frequency point of "step size" you have set.
11
In VFO mode, press the Main Band
21
During the scanning adjust the Main band selector knob or press
microphone [ UP/DOWN ] key will change the scan direction.
31
Press
key to exit scan.
c h Ann el ScAn
11
In channel mode, press the Main Band
key to enter channel scan.
key to enter channel scan.
Shortcut Operations
21
During the scanning, adjust the Main band selector knob or press
microphone [ UP/DOWN ] key will change the scan direction.
31
Press
key to exit scan.
chAnnel ScAn Skip
In channel mode, switch selector knob to
choose the channel, then hold
second, the radio prompts "DU DU", and LCD displays "SKIP", and now
the current channel is Scan Skip.
chAnnel edit
11
In VFO mode, turn selector knob to select the desired frequency or
input frequency by MIC's numeric keys.
21
Hold
key until the transceiver prompt
DU and the display of channel number flashes.
31
Turn selector knob to select the channel number to store. (If the
storage has data, the LCD will display the
frequency, otherwise will display"----------")
41
Hold
key, the LCD display MEN- IN, the channel edit completed.
ScAn RAnGe liMit
You can set the VFO scan frequency range by this function:
11
Choose upper limit and lower limit frequency, there are L1/U1- L5/
U5, five couple of limit frequency for selection. L stands for lower
limit and U stands for the upper limit. the upper limit must over the
lower limit frequency. Please refer to the
Channel Edit to setup the limit frequency.
21
In VFO mode, set the VFO frequency in
the range between upper and lower limit.
31
Press
key to start scan in lmited range.
for over 0.5
6
14
Advertisement
Table of Contents
