Table of Contents
Advertisement
correspondent selector knob, the channel number flashes in this situation,
the channel number will increase 10 channels by each gear of selector
knob. Press microphone [ UP/DOWN ] key also able to adjust the
channel.
If there is any empty channel, the adjustment will ignore it and jump to
next channel.
NOTE
input chAnnel thRouGh MicRophone nuMbeR keY
In channel mode, you can switch to desired channel by press 3 of the
microphone numeric keys (001-758). For example input 001 get channel 1;
input 030 is channel 30; input 512 is channel 512. If the input channel is
not programmed with frequency, the transceiver will emit a warning beep
and return to last channel.
Switch between MAin bAnd And Sub bAnd
This transceiver is default on dual receive, a
"MAIN" icon will display in the top right of the
working frequency. The transmitting is only
available on the Main band. When the left
Band is Main band, press the right selector
knob will switch the right Band to Main band. Then press the left selector
knob will switch the left Band to Main band.
SelectinG the FRequencY bAnd
1. Choose for Left band: press the left side
mode, press the left selector knob over 1 second then repeat above
operation will switch the left band between 108~180Mhz (RX: 108-
174Mhz, TX: 136-174Mhz), 220~260Mhz (RX only), 350~399.995Mhz
(RX only) or 400~523Mhz.
2. Choose for right band: press the right side
VFO mode, press the right selector knob over 1 second then repeat
above operation will switch the right band between 136-174Mhz,
400~523Mhz.
In standby, both left band and right band are
able To receive. When they receive any signal,
the "BUSY" icon and signal strength icon will appear in the corresponding
area of the LCD. And you can hear the calling.
Long press of
Off Momentary to monitor the weak signal.
1. Squelch Off: Hold
2. Squelch Off Momentary: Keep hold
key to switch it to VFO
Hold "PTT" key, the transceiver change to transmitting. Please hold the
Microphone approximately 2.5-5.0cm from your mouth, and then speak
key to switch it to
into the microphone in your normal voice to get best timbre.
Basic Operations
This transceiver can be set working on 2 UHF band or 2 VHF band.
NOTE
ReceiVinG
If the transceiver has set at higher squelch level, it may fail to hear the
"BUSY"
calling. If the
and signal strength icon display in left band or
right band, but can not hear the calling, means the signal is with matching
NOTE
carrier but dis-matching signaling.
Squelch oFF/Squelch oFF MoMentARY
key can be programmed as Squelch Off or Squelch
key until hear "Du" beep, the squelch is off,
repeat the above operation to resume squelch.
release the key to resume squelch.
In standby, press the microphone
to turn on the squelch.
NOTE
tRAnSMittinG
The transmitting only available on Main band, the "TX" icon will display in
the top right corner of the Main band frequency
NOTE
5
key to disable squelch,
to cancel squelch, press it again
.
12
Advertisement
Table of Contents
