Shortcut Operations; Squelch Level Setup; Home Channel; Editing Home Channel - AnyTone 5888UV III User Manual

6

Shortcut Operations

Squelch leVel Setup

This function is used to setup the strength of receiving signal, when the
strength reach a certain level, the calling can be heard, otherwise, the
transceiver will keep mute.
In standby, press and hold
to adjust the squelch level of Main band.
1-20: Total 20 squelch levels available.
OFF: turn off squelch. The background noise always on.
The squelch level shall setup separately for right band and left band.
NOTE

hoMe chAnnel

In standby, press key to switch to HOME
channel, and communicate on HOME channel.
11
repeat pressing it to return to last channel.

editinG hoMe chAnnel

In VFO mode, after setting desired freq and
Channel, press then hold
announces"DUDU", LCD displays H icon,
Home channel editing finished.
key, meanwhile switch the selector knob
until radio

hypeR MeMoRy chAnnel

In standby, press the left or right volume knob will switch the radio work
on hyper channel 1 or hyper channel 2.

duAl wAtch

In standby, hold key for over 0.5 second to enter Dual Watch mode.
The radio will scan the channel in every 5 seconds. When the radio
receives matching signal, it pause scanning until the signaling disappear.
Repeat above operation to exit Dual watch.

eMeRGency AlARM

To start emergency alarm, hold the right volume knob until the trans
-ceiver displays ALARM and emit alarm. Re-power on the transceiver to
exit alarm. This transceiver has 4 kind of alarm.

chAnnel/FRequency ScAn

F R equenc y Sc An
In VFO mode, this function is designed to monitor signal of every
communicative frequency point of "step size" you have set.
11
In VFO mode, press the Main Band
21
During the scanning adjust the Main band selector knob or press
microphone [ UP/DOWN ] key will change the scan direction.
31
Press key to exit scan.
c h Annel S c A n
11
In channel mode, press the Main Band
key to enter channel scan.
key to enter channel scan.