Securing The Chimney; Installing The Front Shelf Brackets; Mounting The Front Shelf - Pit Boss PB0820SPW Assembly Manual

7. SECURING THE CHIMNEY

Parts Required:
1 x Chimney Gasket (#6)
1 x Chimney (#7)
2 x Screw (#A)
2 x Washer (#B)
2 x Locking Washer (#C)
Installation:
• Locate the chimney opening on the side of the Main Barrel. From the
outside, secure the Chimney Gasket and Chimney to the side panel
using two screws, locking washers, and washers. The screw will fasten
to the pre-mounted nut on the inside of the Main Barrel.
NOTE: Ensure the chimney cap allows for air to escape.

8. INSTALLING THE FRONT SHELF BRACKETS

Parts Required:
1 x Front Shelf Bracket / Left (#23)
1 x Front Shelf Bracket / Right (#24)
6 x Screw (#A)
6 x Washer (#B)
6 x Locking Washer (#C)
Installation:
• Attach one Front Shelf Bracket to the front of the Grill Barrel by using
three screws. Install each screw half-way, then tighten completely
when all three screws are mounted and aligned properly. Repeat the
same installation for the other Front Shelf Bracket.

9. MOUNTING THE FRONT SHELF

Parts Required:
1 x Front Shelf (#22)
2 x Screw (#D)
2 x Nut (#H)
Installation:
• From underneath, insert the screw (from the inside) into the Front
Shelf and the Front Shelf Bracket, then lock it with a nut. Repeat
installation for the other side of the Front Shelf.
NOTE: When installed correctly, the Front Shelf can be raised (for use) or
lowered (for storage) with ease.
IMPORTANT: Avoid using the shelves to move or lift the grill. The
weight of the unit will cause the shelves to break, which is not covered
by warranty.
8
7
7
6
8
23
18
B
A C
9
D
H
22
B A
C
24