Assembling The Side Shelf; Mounting The Side Shelf; Securing The Chimney - Pit Boss PRO Series Assembly And Operation Manual

6. ASSEMBLING THE SIDE SHELF

Parts Required:
1 x Side Shelf (#26)
3 x Tool Hook (#D)
Installation:
• Turn the side shelf upside down. On the edge of the side shelf with
three holes, install the tool hooks into each hole along the edge. The
tool hooks will secure to the nut that is pre-mounted on the inside.

7. MOUNTING THE SIDE SHELF

Parts Required:
4 x Screw (#A)
4 x Locking Washer (#C)
4 x Washer (#B)
Installation:
• From underneath, fasten the side shelf to the side panel of the main
barrel using four screws, locking washers, and washers.
NOTE: Do not tighten screws completely until all screws have been
installed. Once all screws are installed, then tighten securely.
IMPORTANT: Avoid using the shelves to move or lift the grill. The
weight of the unit will cause the shelves to break, which is not
covered by warranty.

8. SECURING THE CHIMNEY

Parts Required:
1 x Chimney Cap (#9)
1 x Chimney Stack (#8)
1 x Chimney Gasket (#7)
2 x Screw (#A)
2 x Locking Washer (#C)
2 x Washer (#B)
Installation:
• Locate the chimney opening on the side of the main barrel. From the
outside, secure the chimney and chimney gasket to the side panel
using two screws, locking washers, and washers. The screw will fasten
to the pre-mounted nut on the inside of the barrel.
• Next, secure the chimney cap onto the top of the chimney stack by
rotating the chimney cap screw into the chimney stack.
NOTE: Adjust the chimney cap to affect the airflow inside the main
grill. If cooking at low temperature, keep the cap more open. Ensure
the chimney cap allows for air to escape.
6
D
D
D
7
8
9
8
7
26
9