Table of Contents
Advertisement
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
9.
Conversion to LP Gas
Fig. 9.1
Burner head
Burner base
Fig. 9.2
Fig. 9.3
ArtNo.0102-0011 - Screwing
the control valve bypass screw
Centre burner
Large burners
Right front burner
Brass venturi
Natural Gas
LP Gas
165
107
120
82
95
64
Table 9.1
Check the 'Technical Data' section at the back of the book
that the hob is convertible to the gas you want to use.
A suitably competent person must perform the conversion.
After conversion the installation must comply with the
relevant regulations and also the local electricity supply
company requirements. Read the instructions before
converting this appliance.
Failure to convert the appliance correctly could
n
invalidate any warranty or liability claims and lead
to prosecution.
When servicing or replacing gas-carrying
n
components disconnect from the gas supply before
starting operation. Check the appliance is gas sound
after completion.
DO NOT use reconditioned or unauthorised gas
n
controls.
Disconnect from the electricity supply before
n
servicing. Before electrical reconnection, check that
the appliance is electrically safe.
Injectors
Remove the pan supports and burner heads. Undo the large
brass nut on the top of the brass venturis and remove
(Fig. 9.1).
Removing the Jets
Either:
Use a long box spanner to access and remove the old jets;
Or:
Lift up the front of the hotplate top and prop it up to access
the burner bases. Remove the old jets.
Save the jets removed from the appliance for possible future
use. Fit the new jets: see Table 9.1 for the correct type.
Note: If you have lifted up the hotplate then carefully
replace it taking care not to damage or displace the ignition
electrodes or flame safety probes (Fig. 9.2) and replace the
rear fixing screws.
Tap Adjustment
Pull off all the control knobs. Open the grill door and right-
hand oven door, and remove the fixing screws underneath
the control panel. Remove the 3 fixing screws at the top of
the control panel.
Pull the control panel forward. Take care not to damage it, by
protecting it with cloth for example, rest it on the open grill
door and oven door.
Turn the bypass screw on each control clockwise until it stops
(Fig. 9.3).
Refit the control panel and control knobs.
30
Advertisement
Table of Contents
