Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have finished.
Current Operated Earth Leakage Breakers
The combined use of your cooker and other domestic
appliances may cause nuisance tripping, so we recommend
that the cooker is protected on an individual RCD (Residual
Current Device) or RCBO (Residual Current Breaker with
Overload).
IF IN DOUBT, PLEASE CONSULT A SUITABLY QUALIFIED
ELECTRICIAN.
Fig. 8.12
L
N
10 mm² max
230 Vac 50 Hz
Fig. 8.13
L1
N
L3
L2
6 mm² max
3N ac
230/400 V 50 Hz
Fig. 8.14
ArtNo.281-0026 - Front plinth
INSTALLATION
Pressure Testing
The gas pressure can be measured at one of the hotplate
burner injectors (not a wok burner).
Lift off a burner head. Fit the pressure gauge to the injector.
Turn on and light one of the other hotplate burners.
Turn on the control knob for the burner with the pressure
gauge fitted to let gas through.
See the data badge for test pressures.
Turn off the burners. Make sure that you reassemble the
burner top in the correct way on the burner body.
Electrical Connection
The cooker must be installed by a qualified electrician, in
accordance with all relevant British Standards/Codes of
Practice (in particular BS 7671), or with the relevant national
and local regulations.
Note: The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker, through
6 mm² max
a suitable cooker control unit incorporating a double pole
switch, having a contact separation of at least 3 mm in all
poles.
The cooker must not be connected to an ordinary domestic
power point.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect
the mains cable to the correct terminals for your electrical
supply type (Fig. 8.12 and Fig. 8.13). Check that the links are
correctly fitted and that the terminal screws are tight. Secure
6 mm² max
the mains cable using the cable clamp.
Final Checks
10 mm² max
Hotplate Check
Check each burner in turn (refer to the 'Hotplate Burners'
section at the front of the instructions).
Grill Check
Turn on the grill control and check that the grill heats up.
Oven Check
Turn on the ovens. Check that the oven fans start to turn and
that the ovens start to heat up.
Turn off the oven.
Fitting the Plinth
Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw. Twist
and fit each end keyhole over their respective screws. Tighten
the fixing screws (Fig. 8.14).
28
Advertisement
Table of Contents
